Diy Vaporizer Videos

Diy Vaporizer Rc 3

Just to show the the proportional vaporizing in addition to vid 2

Diy Vaporizer Rc 9.5 Drift Fake Smoking Tires

This time with mounted body and driving d. the vaporizer is the same as in vid 9. at the end one the wires got loose and was hitting the fan. have to improve the connection to be able to run a bit longer.

Homemade Vaporizer Hit

Hit from my new homemade vaporizer. all i had was this fresh resin ball

Homemade Volcano Vaporizer For Cheap ...

Herbal vaporizers.info homemade volcano vaporizer for cheap http

Using The Diy Vaporizer Pt 2

Using the vaporizer from article on stonedworld.net

Diy Vaporizer Rc 7

This time with a custom build fancase and a 25ml tank for the fluid mounted on an mi3 chassis. r 1,3ohm p 80w . something gone wrong on oxidizing the webbing . burned the vaporizer in the last seconds.

Diy Vaporizer Rc 4

New vaporizer concept based on stainless steel wool.

Diy Vaporizer 11.5 Stitching The Head

This is how i stitch the head using 3mm carbon tow. just do a half stich on each side. the rows must not ovelap. note carbon particles can cause cancer. dont be stupid like me wear a mask and glows.

Diy Vaporizer Rc 9

To prevent burning i am using two vaporizers in series. each one with 2.5ohm. no burning, no spaks but a bit less fog.

Shade Chylde's Diy Vaporizer V2.0 Smokin Design...

A new spin on the j man's original design, hopefully a sleeker 2.0 model...

Preparing Bulb For Diy Vaporizer

This is part of a post that is on stonedworld.net. please go to the original post for full details. stonedworld.net

How To Make A Vaporizer Without Lookin' Like A Crackhead

No butane fumes, compact, 4 functions, durable, low profile diy vaporizer for under $5 diy kinda' pepo like me, check it out ive seen portable vaporizers cost as much as $300 this fits in your pocket, and its not a ghetto lookin' crack pipe. it works in 4 ways, traditional water pipe, extra water...

Diy Vaporizer Rc 5

This time without the kanthal wire. only stainless steel webbing is used. r 5,3ohm. p 10w

Diy Rc Vaporizer 11.5.1

Same vaporizer as before. outside temperature 3 c, brrrrrrrrrrr. i think in summer it will make a bit more fog. sorry for the driving failures. i am a bit rusty and its pretty hard to steer with frozen fingers

Magic Flight Launch Box Vaporizer Test,homemade

I just made this video to show that it works and how fast it heats up,im trying to show the perspex misting up off the vapor them sucking through then letting it mist again but im only using a camera phone and its not very clear.its amazing how little stuff you need to get the desired effect,about a...

Diy Vaporizer 11.5 Oxidizing The Stainless Steel Mesh

This is how i oxidizide the mesh. cut a piece of mesh roll a tube repeat 3 or more times burn it till it glows put it into water

Homemade Vaporizer

This my homemade vaporizer, its made of plywood margarita glass, and plastic pipe